Carbide Spiral Flute Machine Tap for Cast Iron Blind Hole M3-M16 AlTiN Coated 6H

Short Description:

Solid carbide machine tap developed for gray iron, ductile iron and compacted graphite iron. Spiral flute with Form C chamfer for blind-hole threading on CNC machining and tapping centers.


  • Material: Tungsten Carbide (WC-Co, submicron grain, 10% Co)
  • Type: Threading Tap
  • Hardness: HRA 91.5–92.5
  • Coating: PVD AlTiN (AlCrN / TiCN / Uncoated optional)

Product Detail

Product Tags

cast-iron-tapping-tool_banner

Bullet Points

Carbide substrate selected for abrasive wear. WC-Co with submicron grain, HRA 91.5–92.5, TRS ≥ 3800 N/mm². Holds hardness at the cutting temperature generated when machining abrasive cast iron, where HSS taps lose edge sharpness first.

PVD AlTiN coating, 2–4 μm. Reduces friction and flank wear on the abrasive iron carbide and sand inclusions typical of cast surfaces. AlCrN and TiCN alternatives available.

40° spiral flute, right-hand cut. Directs chips backwards out of the hole instead of packing them at the bottom — the main failure mode of blind-hole tapping.

Form C (2P) chamfer. Short chamfer reaches close to the hole bottom and keeps full thread depth. Form B (4P) and Form E (1.5P) available.

Ground thread, 6H to ISO 965-1. 100% checked with go/no-go gauges before packing. 6G available where a thicker coating must be compensated.

Optional axial coolant holes from M6. Essential for gray iron: the powdery chip must be flushed out, otherwise it accumulates in the flute on deep blind holes.

Reinforced DIN 371 shank. Higher section modulus on small diameters (M3–M10) reduces deflection and breakage under CNC rigid tapping.

cast-iron-tapping-tool_800-544

Applications

Automotive: engine blocks, cylinder heads, transmission and clutch housings, brake calipers, differential housings

Pump and valve: pump bodies, valve bodies, flanges, fittings with sealing threads

Hydraulics: manifold blocks, cylinder bodies, end caps

General machining: machine bases, gearbox castings, brackets, frame components

Hot Q&A

  1. Which cast iron grades does this tap suit?

Answer: Gray iron HT200–HT300, ductile iron QT400–QT700, compacted graphite iron and malleable iron. It is not recommended for steel, stainless steel, aluminium or copper — those need different rake angles and coatings.

  1. Can I use it for through holes?

Answer: For through holes we recommend a straight flute or spiral point tap — chips are pushed forward and evacuation is cleaner. This spiral flute model is optimized for blind holes.

  1. Do I need internal coolant?

Answer: For ductile iron, external emulsion is usually sufficient. For gray iron blind holes deeper than 1.5×D, internal coolant or high-pressure air is strongly recommended, because the powdery chip otherwise packs in the flute. Internal coolant holes are available from M6.

  1. What cutting data do you recommend?

Answer: vc 40–70 m/min for gray iron, 30–60 m/min for ductile iron, 25–50 m/min for CGI; feed equals the thread pitch. Always confirm with a trial cut on your own workpiece and casting skin condition.


  • Previous:
  • Next:

  • Write your message here and send it to us